Adafruit 875 Battery Holder (8 x AA) with 5.5mm/2.1mm plug and switch
Make a portable power brick with plenty of juice! Use Alkaline AA's for a 12V 3000-4000mAh power supply, or rechargeable NiMH for 2000mAh 9.6V supply. Either one is good for running electronics that have a 5V voltage regulator (thus requiring a 7V+ supply) or perhaps some motors or solenoids.
Perfect for portable Arduinos, motors, solenoids, 12V LED strips, etc. An On/Off switch lets you control the power right at the source without unplugging. Batteries not included, may or may not include screws.
The DC lead (including the plug) is approximately 6 inches long
- Batteries: 8 AA
- Batteries Included: No
- Height: .76 inch
- Length: 5 inch
- Outputs: 5.5mm/2.1mm Barrel
- Width: 2.8 inch
Downloads:
• Manufacturer's Product Information
