RX480 4-Channel Receiver + Remote, 433.92MHz
4-Channel Remote Control (Clone-capable) and 4-Channel Receiver Module
The 4-channel receiver operates on 433.92MHz and is a perfect match for the included 4-Channel remote control (available separately as GG-DIY-RC1).
The module has 1 pin per channel, plus power pins and a combined status/learn pin. The coiled antenna is already soldered onto the board.
The receiver works with EV1527 learning codes and PT2262 fixed codes.can clone other compatible 433.92 MHz remote controls, in fact you can clone multiple single-channel remote controls.
The on-board learning button determines the operating mode (momentary, toggle, latching). The learn-button can also be emulated through the combined status/learn-pin for use with a microcontroller.
The remote comes with a key-ring attachment / carabiner, and it features a green activity LED. The required 27A-style 12V battery is already installed.
The remote can clone other compatible 433 MHz remote controls, in fact you can clone multiple single-channel remote controls.
Instructions
When you press a button and the green LED stays lit, then the remote is transmitting. If the LED only lights up briefly, the button is not programmed.
To program a button (i.e. to clone another remote's button into this remote), press and hold the button on the other remote, and while doing so press the button on this remote control until the green LED stays lit. That's it !
Note that you can only clone to buttons that are not yet used. You cannot selectively clear or overwrite a button that's already assigned
You can clear ALL buttons by pressing and holding A and B at the same time
You can restore the last configuration by pressing and holding C and D at the same time
- Channels: 4
- Frequency: 433.92 MHz
